Important tips for installing, setting up and using the pump correctly
Pump-Melal industries
Dear customers, it is necessary to observe the following points before and during the use of foam and sludge pumps.
- It is possible to use the scum pump for pools, deep wells, tall buildings, fields, streams, fountains, gardens and waterlogged areas.
- Use a fine net to prevent sand or mud from entering.
- Do not use the cable and pump handle to lower the pump.
- The electric voltage used for all types of pumps should not be less than 220 volts.
- The power of the pump should be used directly from the meter and the miniature meter with the appropriate ampere.
- For pumps up to a height of 30 meters and two inches, a 10 amp miniature switch should be used.
- For 45-meter two-inch pumps and above, use a 16-amp miniature switch.
- In case of adding a cable to the pump, make sure to use a stronger cable than the cable of the pump itself.
- The place where the pump is used must be sealed
- Pay attention to the important points recorded on the pump plate.
- Use a grounding wire.
- When the pump is working, the whole pump must be in the water.
- The pump should never be used horizontally.
- Do not open the pump screws separately.
- The use of submersible pumps is only for use in clear water.
- If the pump is used for drilling a well, etc., the consumer is responsible for any injuries and damages.
- Improper use of the pump will void the warranty.
- If there is a problem with the pump or to get information, please refer to the authorized representatives of the pump throughout the country.
- Never run the pump without water
- The warranty of all types of pumps can only be used with an official invoice from the sales representatives of the company
- Do not pour water inside the engine because the engine is full of oil and works with oil.
